SECTION 2 – DEFINITIONS

SECTION คำชี้แจง
- ถ้าไม่กรอกทั้งชื่อ และนามสกุลของผู้ทำข้อสอบ ระบบจะไม่ตรวจข้อสอบให้
- ส่วนนี้จะไม่มีการบันทึกผลสอบ หากต้องการบันทึกโปรดสมัครสมาชิก
- ถ้าทำข้อสอบไม่ครบ ระบบจะไม่ตรวจข้อสอบให้
- ผู้ทำข้อสอบจะมีเวลาในการทำข้อสอบเพียง 30 นาที หากเกินเวลา ระบบจะไม่ตรวจข้อสอบให้
- เกณฑ์ตัดสินผ่านการทดสอบอยู่ที่ร้อยละ 90 หรือ 18 ข้อขึ้นไป
ส่วนนี้จะไม่มีการบันทึกผลสอบ และแสดงเฉลยแบบทดสอบ หากต้องการบันทึก และรายงานการทำแบบทดสอบ โปรดสมัครสมาชิก 
1. 2.37 How is draft defined?
    a. The vertical distance from the surface of the water to the keel of the ship
    b. The vertical distance from the deck of the ship to the surface of the water
    c. The vertical distance from the Plimsoll mark to the bottom of the ship
    d. The vertical distance from the Plimsoll mark to the deck
2. 2.13 What is relative density?
    a. The ratio of the mass of a given volume of liquid at a stated temperature to the mass of an equal volume of pure water at a stated temperature
    b. The relative ability of a liquid to remain in a liquid state when cooled below standard freeze point
    c. A measure of the relative viscosity of a liquid
    d. The ratio of a given mass of a liquid when compared with its mass at 60 °F
3. 2.16 What is Gross Observed Volume (GOV)?
    a. The total measured volume of all petroleum liquids, sediment and water, and free water at observed temperature
    b. The total volume of all petroleum liquids and sediment and water, excluding free water, at observed temperature
    c. The total volume of all petroleum liquids excluding sediment and water and free water, at observed temperature
    d. The total volume of all petroleum liquids and sediment and water, excluding free water, corrected to a standard temperature by the appropriate volume correction factor for the observed temperature and density
4. 2.38 How is trim defined?
    a. The same as the draft
    b. The difference between the forward and aft draft
    c. The average of the forward draft, the amidships draft, and the aft draft
    d. The leaning of the vessel to one side
5. 2.36 How is Gross Observed Volume (GOV) defined?
    a. The volume read from the strapping table
    b. The total volume of all petroleum liquids and sediment and water, excluding free water, at observed temperature and pressure
    c. The volume read from the strapping table corrected for roof displacement
    d. The volume used to calculate vessel ratios
6. 2.10 What is deadwood?
    a. Wooden cup-case thermometer cases that are no longer fit for use
    b. Any piece of gauging equipment made of wood (i.e. wooden handles of gauge tapes, cup-case thermometer cases) that have been exposed to chemicals and have been damaged as a result
    c. Any tank fitting or structural member inside a tank that affects the capacity of the tank
    d. Answers a., b. and c. are all wrong
7. 2.26 The Net Standard Volume (NSV) is the Gross Standard Volume (GSV) less?
    a. Total Calculated Volume (TCV)
    b. Total Observed Volume (TOV)
    c. Gross Standard Volume (GSV)
    d. Sediment and Water (S&W)
8. 2.15 What is Total Observed Volume (TOV)?
    a. The total measured volume of all petroleum liquids, sediment and water, and free water at observed temperature
    b. The total measured volume of all petroleum liquids, sediment and water but excluding free water, at observed temperature
    c. The total volume of all petroleum liquids and sediment and water, corrected to a standard temperature by the appropriate volume correction factor for the observed temperature and density
    d. The total measured volume of all petroleum liquids excluding water and sediment, at observed temperature
9. 2.04 What is a permanent ballast tank?
    a. A tank that contains ballast at all times
    b. A tank that is designated to contain only ballast
    c. A tank that is used only to maintain a permanent list condition
    d. Answers a., b. and c. are all wrong
10. 2.07 What is a Bill of Lading?
    a. A receipt for the cargo
    b. Evidence of the contract
    c. A document confirming ownership of cargo
    d. Answers a., b. and c. are all correct
11. 2.33 What is the name given to the factor calculated from the ratios of historical Total Calculated Volumes (TCV) of a vessel (less OBQ/ROB) with the corresponding historical Total Calculated Volumes (TCV) of shore delivered/received volumes?
    a. Voyage Analysis Factor
    b. Tank Correction Factor
    c. Vessel Experience Factor
    d. Ullage Correction Factor
12. 2.31 What is the term for the amount to be paid by the Charterer if a vessel is delayed beyond the terms allowed in the Charter Party?
    a. Dispatch money
    b. Demurrage
    c. Disbursement
    d. Penalty money
13. 2.03 What is ballast?
    a. Water in the tanks of a vessel used for laundry and other sanitation purposes
    b. Any water on board a vessel in any tank
    c. Water that is used to clean cargo tanks
    d. Water that allows the vessel to maintain stability and to control stress and trim
14. 2.08 What is clingage?
    a. The wedge shaped volume of oil remaining in a tank after discharge
    b. The non-liquid wedge-shaped volume of oil remaining in a tank after discharge
    c. The cargo that adheres to the internal vertical surfaces of a tank after it has been emptied.
    d. The ability of a liquid to cling to the inside surface of a container
15. 2.20 How is an all levels sample obtained?
    a. By submerging an unstoppered sampler to a point near the tank draw-off outlet (suction) level and then raising it, all at a uniform rate, so that it is no more than 85% full on emerging from the liquid.
    b. By blending upper, middle and lower samples from the same tank.
    c. By submerging a stoppered sampler to a point as near as possible to the draw-off outlet (suction) level, then opening the sampler and raising it at a rate such that it is no more than 80% full as it emerges from the liquid.
    d. By submerging a stoppered sampler to the mid point of the product in a tank, then opening the sampler and raising and lowering it at a uniform rate until the sampler is full.
16. 2.05 What does the abbreviation S&W stand for?
    a. Sand and Water
    b. Sediment and Waste
    c. Scale and Water
    d. Sediment and Water
17. 2.23 What is the total volume of all material in a tank at the observed temperature called?
    a. Total Calculated Volume (TCV)
    b. Total Observed Volume (TOV)
    c. On Board Quantity (OBQ)
    d. Gross Observed Volume (GOV)
18. 2.44 A US barrel has a volume of?
    a. 55 US gallons
    b. 1 cubic meter
    c. 5 liters
    d. 42 US gallons
19. 2.22 What is a floating roof tank?
    a. A tank in which the roof floats freely on the surface of the liquid contents at all levels.
    b. A tank in which the roof floats freely on the surface of the liquid contents except at low levels when the weight of the roof is supported by its legs.
    c. A tank in which the roof, supported by guide wires, can be adjusted to the required height for safe filling of the tank
    d. Answers a., b. and c. are all wrong
20. 2.24 What is the volume of all material in a tank at the observed temperature less the free water called?
    a. Total Observed Volume (TOV)
    b. Gross Standard Volume (GSV)
    c. Gross Observed Volume (GOV)
    d. Remaining On Board (ROB)
ให้ตรวจสอบชื่อนามสกุลว่ากรอกครบหรือไหม่
พร้อมกับตรวจข้อสอบว่าเลือกทำครบทุกข้อหรือไม่ ไม่ครบไม่ตรวจนะครับ
แนะนำชุดข้อสอบ

1. แนวข้อสอบวิทยาศาสตร์ ประถมศึกษาปีที่ 4 ชุดที่ 1


2. แบบทดสอบหลังเรียน เรื่อง กีฬาแบดมินตัน


3. แบบทดสอบวิชาบาสเก็ตบอล


4. ข้อสอบ บรรจุครูผู้ช่วย วิชาเอก ปฐมวัย พร้อมเฉลย 50 ข้อ


นำแบบทดสอบไปติดที่เว็บของคุณ


EDUCATION RESEARCH | หน้าแรกข้อสอบ | เข้าระบบ | สมัครสมาชิก | สร้างข้อสอบ | แชร์ข้อสอบ
แนวข้อสอบบรรจุครูผู้ช่วย | TOEIC Online | IELTS Online | SAT | TOEIC | IELTS